Saturday, August 18, 2012

Bullet casting part 9 of 9

To start at the first video click here.This is a 9 part  bullet casting seminar giving complete information on casting that is normally left out of other videos and publications. This represents a tremendous savings in books and study for those patient enough to set through the whole thing. After watching these 9 videos you can know what the experts know. This is years of research and knowledge learned from my personal study and  experience with casting. Much of this is not even written in casting books. You will be shown how to restart your casting pot quickly  when it stops and how to warm your ingots so they will not chill your pot, and a substitute air barrier which eliminates fluxing, as well as speed casting with a single mold without having the mold overheat --leading.This generic message will appear over each video so as to give a person starting in the middle the chance to start from the beginning. Below where it says click here it will allow you to move to move to the next video without having to hunt for it.  To see my book click my name  Richard W Norman
End of seminar

To see a post on hardening bullets with a toaster oven and water quenching click here
To see a good place for lead salvage (2000 to 3000 pounds 4% antimony) from a sales boat click    Boat Keel Bullets 


If they pass laws against guns then you will either make your supplies at home, salvage or do without. 

No comments:

Post a Comment